Use a higher-rated inverter or a lower-rated device. The continuous load demand from the device exceeds the inverter’s wattage output. The inverter will automatically restart after the voltage drops below 15.5 volts. The vehicle’s battery voltage is more than 15.5 volts. See warranty and call Customer Service at 1-80 (Hours: 7 a.m.
If you continue to have issues with your power inverter, please contact customer service for assistance. To troubleshoot your power inverter, please see the chart below listing the common errors your power inverter might display with the associated reason and solution. Exceeding the recommended time duration of your charger’s cranking assist cycle can cause damage to the charger’s internal circuitry. Recommended cranking assist cycles less than 5 seconds are in place to allow the charger to dissipate the heat generated by the increased power output through the transformer.
Doing so could cause damage to your battery or cause other property damage or personal injury. NOTE: You should not attempt to charge your battery on the engine start setting. If the engine fails to start within 3 to 5 seconds, stop cranking and begin the cranking process again by charging your battery for another 10 to 15 minutes. Then try to start the engine using the ignition switch. After 15 minutes of charging, set the selector switch to the Engine Start/Cranking Assist position. Charge the battery for 15 minutes before using engine start/cranking assist. See the front panel of your charger for the recommended crank time your charger allows. We recommend using the engine start/cranking assist feature on your charger for 3 to 5 seconds on and 5 minutes off.